LAB 01 - Using External Numeric Modules.pdf

(73 KB) Pobierz
External Modules
Using External Numeric Modules
Task:
Create a new External Numeric Module inside of Designer and link the module to a
control object and numeric object inside of Vista to explore its behavior.
Condition:
20 minutes (time limit for student to complete lab)
Sources: PME System Guide, ION Reference Guide
Version 5.0
Public
External Modules
Steps:
1. Open the
ION Reference
document and find the External Numeric Module
section.
2. Open up the Designer application. Then open the
VIP
node by clicking
File >
Open
and selecting the
VIP.DEFAULT
node from the list of available nodes.
3. Create a new
Grouping Window
inside of the VIP called
External Modules
and
open it up.
4. Find the
External Numeric Module
inside of the Designer toolbox by matching
the picture inside of the ION Reference document to the corresponding picture
inside of the Designer Toolbox. Click and drag a new module onto the screen.
5. Modify the setup registers of the module and change the module label to say
Numeric Module
and the output label to say
Numeric Value.
6.
Send and save
the changes made.
7. Open up Vista, and create a new screen called
External Modules
and link both
a
Numeric Object
and a
Control Object
to this External Numeric module that
was just created in the VIP.
Version 5.0
Public
External Modules
Example configuration of Numeric Module inside of Designer
Example screen created inside of Vista.
Version 5.0
Public
External Modules
Questions:
1. What is the initial value of the module?
2. What happens when you type in a number into the control object in Vista?
3. Can Control objects be used through the Web interface?
4. Can you change the value of the module inside of Designer?
5. What happens if you copy and paste the External Numeric Module in Designer
after a number has set?
6. What would be some uses for this module?
Version 5.0
Public

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin