MMI3G Software update 22 presentation part one.pdf

(164 KB) Pobierz
SO ST
Service Engineering Special Training
06/2009
Contents
Technical innovations: Electronics
Contents: Technical innovations
Electronics
No.
Event
Topic
Type/model
1
06/09
Current MMI3G software update
All
Contents
Technical innovations
Electronics
Current MMI3G software update
Overview of modifications to software
-
Modified software in response to “Totalausfall” (Total failure) complaint
-
New TV tuner software to prevent breakdowns
-
Correction of incorrect seat heating display after bus sleep mode
-
Separate volume adjustment for ring tone and hands-free
-
Navigation system calibration reset via diagnostics.
-
Some items in MMI menu renamed (e.g. “Parking System” (Parking system)
-
Station names correctly sorted into alphabetical order
-
Time taken to display Tooltip reduced from three to two seconds
-
Navigation system map scale when using SDS rectified
-
Changes to voice activation in SDS
Note: new language CD required for 8DP; 4G0 919 884 E
-
Attribute for one-way streets integrated. Change to avoid using “Bitte wenden” (Please make a U-turn) when driving
in a one-way street.
-
Revised route mapping for tunnels and bridges
-
Showroom mode for component protection:
If an Infotainment system without a terminal 15 cycle is switched on 30 times, component protection is activated.
In this mode, various functions are either limited or deactivated depending on the system. The ignition must be switched on
in order to exit component protection mode.
If component protection mode is active, a screen appears displaying the message “Eingeschränkte Funktion..., bitte Zündung
einschalten” (Limited function..., please switch on ignition);
this notifies the customer that component protection is activated. The customer must click out of the screen in order to return
to the main menu.
Contents
“Einparkhilfe” (Parking aid))
Technical innovations
Electronics
Current MMI3G software update
Error message in MMI display when starting the update
A software update was initiated by pressing SETUP+RETURN immediately after switching on the MMI.
The MMI was not fully initialised.
Wait a few seconds until the MMI start-up process is complete, then press RETURN.
This brings you to the required menu.
Contents
Technical innovations
Electronics
Current MMI3G software update
Data memory entries following software update in “5F-Informationselektronik 1”
(5F Information electronics 1)
“SAECode 3276 - Softwareversionsmanagement prüfen” (SAECode 3276 — Check
software version management)
Cause: SVM back-up documentation following software update not successfully created
“SAECode 3175 - ungültiger Datensatz” (SAECode 3175 — Invalid data set)
Cause: Parameterisation following software update not successfully performed
Procedure:
1. Use the update CD again and check that all MMI components have been flashed.
2. Create the SVM back-up documentation with the SVM code from the CD.
3. Work through test plan “5F-Informationselektronik, Fehlerspeicher zurücksetzen”
(5F Information electronics, reset fault memory).
Please ensure that you follow the tester instructions. If the tester indicates that you should contact
the “SVM_Fachbereich” (SVM_Department) or if the back-up documentation process is unsuccessful
again, please send an email to:
SVM_Fachbereich@audi.de
Contents

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin