M5407C3UM.pdf

(1145 KB) Pobierz
M5407C3 User's Manual
M5407C3UM/D
Rev. 1.1, 8/2000
DigitalDNA and Mfax are trademarks of Motorola, Inc.
IBM PC and IBM AT are registered trademark of IBM Corp.
I
2
C-Bus is a proprietary Philips Semiconductor interface bus
All other trademark names mentioned in this manual are the registered trade mark of respective owners
No part of this manual and the dBUG software provided in Flash ROM’s/EPROM’s may be reproduced, stored in a retrieval system, or
transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise. Use of the program or any
part thereof, for any purpose other than single end user by the purchaser is prohibited.
Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty,
representation or guarantee regarding the suitability of its products for any particular purpose, nor does Motorola assume any liability
arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation
consequential or incidental damages. “Typical” parameters which may be provided in Motorola data sheets and/or specifications can
and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals” must
be validated for each customer application by customer’s technical experts. Motorola does not convey any license under its patent
rights nor the rights of others. Motorola products are not designed, intended, or authorized for use as components in systems
intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in
which the failure of the Motorola product could create a situation where personal injury or death may occur. Should Buyer purchase or
use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers,
employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable
attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or
unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part. Motorola
and
are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal Opportunity/Affirmative Action Employer.
How to reach us:
USA/EUROPE/Locations Not Listed:
Motorola Literature Distribution; P.O. Box 5405, Denver, Colorado 80217. 1–303–675–2140
or 1–800–441–2447
JAPAN:
Motorola Japan Ltd.; SPS, Technical Information Center, 3–20–1, Minami–Azabu. Minato–ku, Tokyo 106–8573 Japan.
81–3–3440–3569
ASIA/PACIFIC:
Motorola Semiconductors H.K. Ltd.; Silicon Harbour Centre, 2 Dai King Street, Tai Po Industrial Estate, Tai Po, N.T.,
Hong Kong. 852–26668334
Technical Information Center:
1–800–521–6274
HOME PAGE:
http://www.motorola.com/semiconductors
Document Comments
: FAX (512) 895-2638, Attn: RISC Applications Engineering
World Wide Web Addresses
: http://www.motorola.com/PowerPC
http://www.motorola.com/NetComm
http://www.motorola.com/ColdFire
© Motorola Inc., 2000. All rights reserved.
LIMITED WARRANTY
Matrix Design warrants this product against defects in material and workmanship for
a period of sixty (60) days from the original date of purchase.
This warranty extends
to the original customer only and is in lieu of all other warrants, including
implied warranties of merchantability and fitness.
In no event will the seller be
liable for any incidental or consequential damages. During the warranty period,
Matrix Design will replace, at no charge, components that fail, provided the product
is returned (properly packed and shipped prepaid) to Matrix Design at address below.
Dated proof of purchase (such as a copy of the invoice) must be enclosed with the
shipment. We will return the shipment prepaid via UPS.
This warranty does not apply if, in the opinion of Matrix Design, the product has been
damaged by accident, misuse, neglect, misapplication, or as a result of service or
modification (other than specified in the manual) by others.
Please send the board and cables with a complete description of the problem to:
Matrix Design & Manufacturing, Inc.
2914 Montopolis Drive #290
Austin, TX 78741
Phone: (512) 385-9210
Fax: (512) 385-9224
http://www.cadreiii.com
WARNING
This board generates, uses, and can radiate radio frequency energy and, if not installed
properly, may cause interference to radio communications. As temporarily permitted
by regulation, it has not been tested for compliance with the limits for class a
computing devices pursuant to Subpart J of Part 15 of FCC rules, which are designed
to provide reasonable protection against such interference. Operation of this product
in a residential area is likely to cause interference, in which case the user, at his/her
own expense, will be required to correct the interference.
apps docs:ColdFire:5407:Eval Board UM NEW:5407C3UMTOC.fm
8/14/00
CONTENTS
Paragraph
Number
Title
Page
Number
Chapter 1
M5407C3 Board
1.1
1.2
1.3
1.4
1.5
1.6
1.7
1.8
1.9
1.9.1
1.9.2
1.9.3
1.9.4
1.9.5
1.9.6
1.9.7
1.10
1.11
1.12
General Hardware Description ........................................................................... 1-1
System Memory .................................................................................................. 1-4
Serial Communication Channels......................................................................... 1-4
Parallel I/O Ports................................................................................................. 1-4
Programmable Timer/Counter ............................................................................ 1-5
PCI Controller..................................................................................................... 1-5
On Board Ethernet .............................................................................................. 1-5
System Configuration ......................................................................................... 1-5
Installation And Setup......................................................................................... 1-7
Unpacking....................................................................................................... 1-7
Preparing the Board for Use ........................................................................... 1-7
Providing Power to the Board......................................................................... 1-8
Selecting Terminal Baud Rate ........................................................................ 1-8
The Terminal Character Format ..................................................................... 1-8
Connecting the Terminal ................................................................................ 1-8
Using a Personal Computer as a Terminal...................................................... 1-8
System Power-up and Initial Operation............................................................ 1-11
M5407C3 Jumper Setup ................................................................................... 1-11
Using The BDM Port ........................................................................................ 1-13
Chapter 2
Using the Monitor/Debug Firmware
2.1
2.2
2.2.1
2.2.2
2.2.2.1
2.2.2.2
2.2.2.3
2.3
2.4
What Is dBUG?...................................................................................................
Operational Procedure ........................................................................................
System Power-up ............................................................................................
System Initialization .......................................................................................
Hard RESET Button. ..................................................................................
ABORT Button...........................................................................................
Software Reset Command. .........................................................................
Command Line Usage.........................................................................................
Commands ..........................................................................................................
2-1
2-3
2-3
2-4
2-5
2-5
2-6
2-6
2-6
Contents
PRELIMINARY—SUBJECT TO CHANGE WITHOUT NOTICE
Motorola Confidential Proprietary
v

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin